If you notice any of the common toilet problems described above, it is best to fix the problem immediately. Failure to do so could lead to more complicated problems and expensive repairs. Most toilet problems are easy to fix, but if you’re unsure of your skills, call a plumber. You’ll be glad you did. Read on to learn how to diagnose and repair the most common toilet problems.

Float ball drags arm too low in tank

If you have an issue with the float ball in your toilet dragging an arm too low in the tank, you should first check to make sure it’s not blocked by something else. First, check the trip assembly. If the ball is dragging itself, this could be due to the overflow pipe. If so, you can remove the lid to flush the tank. If the float ball is not dragging water, it may need to be bent up.

Bad flapper

You may be experiencing problems flushing your toilet due to a broken flapper. This problem may also be caused by a damaged toilet flapper chain. To fix this problem, you can tighten the chain by hooking it to a higher lift bar. However, if you still cannot flush the toilet after tightening the chain, it may be due to a bad flapper valve. Luckily, the replacement flapper is relatively easy to find. Here are the steps you should take:

First, determine where the flapper is leaking. If it’s near the bottom of the tank, this problem may be coming from the flapper. You can test this by using a drop of dye and waiting 15 minutes. If the dye shows up, the flapper is leaking. Warped or poorly fitting flappers can waste up to two hundred gallons of water every day. This could cost you hundreds of dollars every year.

Slow-filling toilet

If you have a slow-filling toilet, it could be due to a number of issues. These issues range from a dirty flapper and flush valve to a cracked or corroded cistern. Depending on the cause, you can easily replace either of these components yourself, or call a plumber. However, if you are not confident about your DIY skills, it may be necessary to call a plumber. Hire CanduPlumbers for Top-Notch Toilet Repair in San Fernando Valley and Around Areas

First, check the water level in your tank. If it’s at the top, the float ball may have become waterlogged. Replace the float ball if necessary. If it is not, you can upgrade to more modern hardware. Make sure you clean out the valve as well. If the water level in the tank is high enough, you can also replace the inner parts of the toilet. If you don’t have enough funds for an expensive plumber’s visit, you can try some DIY tips to fix a slow-filling toilet.

Overflowing toilet

If your toilet is overflowing, you may want to consult a plumber right away. In some cases, the problem could be related to the main sewer line or the float mechanism. It may also be due to a broken handle or clogged tank. However, the following steps can be helpful to stop the overflowing. Using a plunger to clear the toilet can also be helpful. If you’re unsure of the proper procedure, call a licensed plumber to do the job.

The flapper may not be seating properly. If this is the case, try tightening the flange bolts to prevent the toilet from overflowing. However, remember to be careful not to tighten the bolts too much or they may break. Shimming the base may be another solution. To do this, insert a shim between the toilet and the floor. You must test several sizes to find the right one that fits the location.